D303
Non Silicone Emulsion
D303 is a non-silicon water soluble emulsion type die release agent which is based on refined mineral oils and high purity organic synthetic compounds.
D303 adheres to a die surface of high temperature, while even under relatively low temperature, it is designed to form a “controlled film”. Therefore, it will provide a good die release under a wide range of die temperatures.
Performance Benefits
- Excellent casting surfaces
- No build up or clogging of spray heads
- Suitable range is medium to high temperature
Typical Properties
Appearance: Milky White
Concentration 12 – 15
pH 7.5 – 10.5
Flash Point: None
Use
- Dilute with water
- We recommend an initial dilution rate of 80-140 to 1.
Storage
Products should be stored on their sides in a clean, dry place and protected from extremes of sunlight and high temperature.
Health and Safety
Under normal conditions of use is not known to offer any serious health hazard.
We would however, recommend good standards of industrial hygiene are observed when handling this product.
Package
18 Liter per Pail / 200 Liter per Drum
